G Screen for Gen 3 Dual Battery Systems

G Screen Monitoring System for Gen 3 dual battery systems.

Keep an eye on the status of your dual battery system

• Monitors voltage levels of both batteries.
• Remote status indicator - shows if the batteries are connected or disconnected.
• Remote boost button - jump start the engine from inside the cab if your cranking battery is dead.

Background changes color to visually show your battery status at a glance

• Green - both batteries are fully charged, and they are connected together
• Yellow - the batteries are below 12.7v, and they are disconnected
• Red - at least 1 battery is below 12v. The screen will blink red a few times per minute to get your attention

Background light turns off after 45 seconds of inactivity

• Preserves battery power
• No glare while driving at night
• Voltage and status is still visible, but without the backlighting

Main Battery Voltage

• Holding this screen down for 3 seconds will turn off the screen. Tap once to turn the screen back on.

Aux Battery Voltage

• Holding this screen down for 3 seconds will turn off the screen. Tap once to turn the screen back on.

Status Screen:

• AUTO mode - the system will automatically connect/disconnect the batteries based on the voltage levels
• AUTO OFF - the batteries are isolated from each other
• AUTO ON - the batteries are connected together
• Hold screen down for 3 seconds to access the Boost menu
• When the background turns white, tap the screen to cycle through the menu
• Stop tapping to select the desired mode
• Selecting Boost On will manually connect the batteries together
• Use this to jump start from the second battery if your main battery is too low to start the engine
• They will remain connected until you select Boost Off or Auto mode
• NOTE all electrical circuits in the vehicle will run from both batteries in this mode
• Selecting Boost Off will manually separate the batteries
• They will remain separated until you select Boost On or Auto mode
• NOTE your Aux battery will not be charged by the alternator while in this mode
• Selecting Auto On will set the system to Automatic mode

144 PSI

• This screen shows the air pressure in your on-board air tank if you have the optional Digital Air Pressure Sensor kit installed
• Without the sensor installed, this screen will not be displayed

Genesis Offroad V5.3

• This screen shows the firmware version
• Holding this screen down for 3 seconds will enter the contrast adjustment menu, allowing you to tap through 5 levels of contrast for optimal viewing

Kit Contents:

• G Screen
• Interface Module
• Ribbon Cable
• Wire Harness
• Panel Cutout Template

Screen measures approximately one cubic inch. Compact size makes it easy to mount anywhere. Includes a 11 foot wiring harness for simple, clean installation. Software upgradeable for future features.

• Add the optional Genesis digital air pressure sensor to monitor the PSI level in your on-board air system.
• Screw the sensor into an available 1/4 inch NPT port on your air tank or manifold
• Attach the waterproof cable to the sensor, and route the cable to the G Screen. Plug the other end into the interface module.
• The G Screen automatically detects the sensor and adds a new screen showing the PSI level in your tank, from 0-150 PSI.
• No air hoses to run, no wiring to figure out!