Close
You have no items in your shopping cart.
Search
Back to All Blog Posts

Rancho Leveling Kit: 2020 Toyota 4Runner TRD

Rancho Leveling Kit: 2020 Toyota 4Runner TRD

Rancho 2.5" leveling kit on a 2020 Toyota 4Runner TRD 4x4

 

Common Tools:

  • socket sizes: 10mm,12mm, 15mm, 19mm, 21mm, 3/4", 13/16", flat head screwdriver, pliers, pry bar, jacks

 

  1. Take off the wheels, and skid plate to start

  2. Take off the tie rod end castle nut and bust it off the knuckle, do the same for the upper control arm nut, the brake line, and abs sensor line brackets off, then take off the 4 sway bar end links bolts on either side, and it will come forward, out of the way.

  3. Next, take out the 19mm nut and bolt out of the lower shock mount, then the 3 nuts on top of the shock mount, slide the old coil/shock out 




  4. Next, grab the new Rancho Quick Loader Coilover and set the dial to where you want both sides, place the shock in the mount, you may need a large bar to press down on the arm to get the lower shock mount in. Tighten up the 3 upper new hardware nuts and then the factory lower bolt and nut. 

  5. Then start putting back the upper control arm joint, tie rod ends, and the sway bar end link (this is the hardest part).

  6. For the sway bar end link, the driver side has the stabilizer shock bar system, this has to be jacked up and pushed back toward the vehicle at the same time while lining up the bracket holes to get the bolts in. 

  7. Once everything is in now tighten up the abs line brackets and torque everything to spec.




Comments
Write a Comment Close Comment Form